WELCOME TO YONGKANG XIAOCHENG POWER TOOLS CO., LTD
Time:2016-12-28 Hits:1017

  Replacing on a regular basis, add professional grease:

  Hammer/electric pick works up to 60 hours (depending on the specific situation should be used depending on the user), add 30 g grease within the cylinder replaced. Yahu.y. ye Hu adopt imported dedicated synthetic high temperature lubricant grease,low temperature high temperature -30C ° ~130C ° normal startup performance, toensure the hammer/electric pick hammer to maximize efficiency, do not add in a hammer/electric pick any brand of oil! if you mistakenly added engine oil in electric pick, can lead to serious oil leakage, shock machines unable to.

  Second, cylinder oils Add method:

  1, first of all, remove machine has changed the grease (such as: cylinder, piston, cylinder boxes and other parts of old oil has changed);

  2, then the surface evenly about the above-mentioned components 0.5-1mm "Yahu.y. Hu/electric pick hammer grease, wild";

  3 and finally, note you must ensure the following parts of the vent or exhaust ductsunobstructed to avoid broken hammer hammering is unable or is due to pores blocked:

  ※ RAM – attention guaranteed RAM hole two grooves at the bottom cannot be blocked by grease must be completely exposed.

  ※ Piston – ensure piston is four? 4-?2 vent unobstructed.

  ※ – Ensure the cylinder cylinder 6 exhaust ducts exposed on the surface out of thebox.

  Three, clamping protection

  Correct use of clamping can further extend the life of the machine, it is recommended that you don't tip in the drilling process flat chisel as a pry bar to use, especially forced power picks to pry the broken objects, so as to avoid clamping fault the Department of electric shovels, and affect your normal use.

  Four, motor maintenance

  Before using the machine 1, to observe the motor inlet and outlet are unobstructed!so as not to cause injury because of the poor thermal motor stator and rotor.

  2, in time to replace the carbon brush and use the brush provided original! use do not match the carbon brush easily damage the commutator.

  3, when using the machine for a long time, while if its impact was reduced, please replace the o-rings on the piston and RAM and replenish, add "Yahu.y. Hu special grease, wild"!

  4, when the disassembly, attention to longer deformed, damaged sealing ring replace! so as to avoid loss of oil and oil leakage.

  Five, the difference between grease and oil lubrication:

  Using grease lubrication electric pick, because fats are solid gel, before work, take some time preheating temperature, so adequate lubrication grease melting, shock electric pick moments to reach the peak.

  Advantages of (oil): good sealing, lubrication full, help protect the cylinder, piston, and extend the life of electric pick. Working longer, better sealing, lubrication, hammer strength will continue to increase, the more the more energetic.

  Disadvantages (FAT): power on takes about 2 minutes to preheat (ambient temperature too low, be prolonged running time). Electric pick of used lubricating oil, oil is itself a liquid, oil does not need to be dissolved after boot, can work immediately.

  Advantages of (oil): power does not need to dissolve, can work immediately.

  Disadvantages (oil): sealing performance, poor lubricating properties, easy oil spill.Hammer/electric pick works longer, seal, lubrication will gradually decay, force decreases.

Previous:Angle Grinder Practice

Next:makute - The 122nd Canton Fair

LINK
CONTACT

export@makute.com

 

Copyright © 2015 Yongkang Xiaocheng Electric Appliance Co.,ltd    Manage    Support:it579.net